priPrinter: revert all changes - priPrinter

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

revert all changes

#1 User is offline   Nadja 

  • Newbie
  • Pip
  • Group: Senior Members
  • Posts: 5
  • Joined: 28-February 10

Posted 13 November 2011 - 11:39 AM

Hi,

How do I revert all changes I've made in priPrinter window?
Pressing undo is kind of long and boring.

Regards,
nadin
-20

#2 User is offline   Aron 

  • priPrinter Support
  • Group: Administrators
  • Posts: 131
  • Joined: 28-February 10

Posted 13 November 2011 - 03:13 PM

You may want to reopen your file. It should be the fastest way.
Thank you,
Aron
-4

#3 User is offline   avavass 

  • Newbie
  • Pip
  • Group: Senior Members
  • Posts: 4
  • Joined: 29-May 12

Posted 29 May 2012 - 06:38 AM

View PostAron, on 13 November 2011 - 03:13 PM, said:

You may want to reopen your file. It should be the fastest way.
Thank you,
Aron


If you open the same file again or any other file, all settings you made remain. It is near impossible to come back and remember all settings you made when you try to make some special print....So, it is absolutely impossible to reset factory default configuration. YOU MUST REMOVE PRIPRINTER AND INSTALL AGAIN...!!!(using a valid uninstaller..or reinstall partition from back-up..)
-1

#4 User is offline   Alex 

  • Administrator
  • Group: Administrators
  • Posts: 238
  • Joined: 28-February 10
  • LocationHungary

Posted 31 May 2012 - 07:22 PM

View Postavavass, on 29 May 2012 - 06:38 AM, said:

If you open the same file again or any other file, all settings you made remain. It is near impossible to come back and remember all settings you made when you try to make some special print....So, it is absolutely impossible to reset factory default configuration. YOU MUST REMOVE PRIPRINTER AND INSTALL AGAIN...!!!(using a valid uninstaller..or reinstall partition from back-up..)


What about applying "Default" theme from themes menu (Page Layout tab) ?
It must restore default settings for the current file.
-1

#5 User is offline   avavass 

  • Newbie
  • Pip
  • Group: Senior Members
  • Posts: 4
  • Joined: 29-May 12

Posted 08 June 2012 - 05:20 PM

View PostAlex, on 31 May 2012 - 07:22 PM, said:

What about applying "Default" theme from themes menu (Page Layout tab) ?
It must restore default settings for the current file.


ok.....i did non see that command...and for me was faster to reinstall partition from DOS (2 minutes 46 sec...for 10 GB of installed software)..
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users